BPS C-100 CPAP Betriebsanweisung PDF herunterladen (Seite 8)

Getting Started

TURNING THE BATTERY PACK ON/OFF

The Battery Pack turns on or off automatically when a device is plugged

into or disconnected from it. If the Battery Pack stops functioning, plug

the AC power supply into a wall outlet and then into the Battery Pack to

reset the internal circuitry.

INITIAL BATTERY PACK USAGE

Before using your Battery Pack for the first time be sure to charge it fully

using AC power (a wall outlet). During the initial charge, the Battery Pack

may indicate that charging is complete after just 10 or 15 minutes as the

Battery Pack is already charged before it leaves the factory.

USING THE BATTERY PACK INSIDE THE CARRYING CASE

The Battery Pack carrying case is designed with a clear access window

which allows the Battery Pack(s) to be used and/or charged while still

inside of the carrying case.

Simply place the Battery Pack in the carrying case with the control board

facing toward the clear access window and pull open the flap to insert the

appropriate connection cord into the Battery Pack.

Power Backup Usage

Standard smart chargers keep the Battery Pack topped off and ready to go

as an emergency power backup during power outages. If a power outage

is immenint or probable, you may connect the PAP device to the Battery

Pack and plug the Battery Pack into a wall outlet. In the event power is

lost the Battery Pack will automatically begin powering the device.

Do not consistently use the Battery Pack as a power backup option as

this will reduce its overall life as the Battery Pack will continue to

charge and recharge (charge cycles). Only use the Battery Pack in this

manner when a power outage is probable or imminent.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 27 28

Keine Kommentare

BPS C-100 CPAP Betriebsanweisung Seite 8